One of the pre-launch projects on my Bristol 24, is a rebuilt teak and cedar sliding hatch. I would like to add a little strength and water resistance to the top boards of the hatch, and was thinking of putting a skin coat of fiberglass on. What is the best material to use, and still be able to see the wood underneath?
Yep- the Gougeon's have built MANY boats covered with fiberglass and clear coated. They make a special clear epoxy for that too.
For this purpose I'd use about a 4 or 6 oz cloth, put it on with WEST epoxy and then put on about 5 or 6 coats of Z-Spar 2015 (or Bristol Finish) We've had good luck with both and our Texas sun is fierce.
Well, the hatch is covered on both sides with 6 oz cloth. Not a real easy job, but the results are good. I first brush on a good coat of epoxy on the bare wood. Then immediately set a pre cut sheet of glass on the board and rolled it flat. I then brushed on another coat of epoxy to fully wet out the cloth. The result was almost clear. I learned to mix up only enough epoxy to quickly do one thing at a time. About 4 1/2 oz of mix was ok. I mixed 9 oz once, and it started smoking and gelled before I was able to use it all.
With a layer of glass on both sides of the hatch boards, it should be very strong and water resistant.